日本在在线在国产日91区精品在线在韩日一区免费人码精品网 日本在在线在国产日91区精品在线在韩日一区免费人码精品网 ,关于置身威锋iphone4论坛一段时间的个人感受 威锋 千 关于置身威锋iphone4论坛一段时间的个人感受 威锋 千 ,人人看国产国自拍亚洲洲免费综合精品无马码网站址avas在线 人人看国产国自拍亚洲洲免费综合精品无马码网站址avas在线

发布日期:2021年10月21日
Configure for Bend Radius

Hose Configuration Requirements

Hose Assemblies are usually connected at both ends in service. They may then either remain in a fixed, or static configuration or in a flexing, or dynamic configuration.

Whether static or dynamic, the First Rule concerning the configuration of the hose is that the bend radius of the hose must never be less than the Minimum Bend Radius (MBR) for the hose as listed in the relevant hose brochure.

日本在在线在国产日91区精品在线在韩日一区免费人码精品网 日本在在线在国产日91区精品在线在韩日一区免费人码精品网 ,关于置身威锋iphone4论坛一段时间的个人感受 威锋 千 关于置身威锋iphone4论坛一段时间的个人感受 威锋 千 ,人人看国产国自拍亚洲洲免费综合精品无马码网站址avas在线 人人看国产国自拍亚洲洲免费综合精品无马码网站址avas在线

The most common situation when this is likely to occur is when the hose is flexed at the end fitting, with stress being applied to the hose at an angle to the axis of the end fitting. Typically, this happens either because the length of the hose is too short, or because the weight of the hose plus contents creates a stress at an angle to the end fitting.

The Second Rule, therefore, if possible, is to design the configuration to ensure that any flexing in the hose takes place away from the end fittings.